Daily maintenance skills of the engraving machine

In fact, the machine and equipment are the same as people, often overloaded, and not well maintained on weekdays will be "ill". People are sick and take some medicine

The interest will be fine. The engraving machine is a kind of precision numerical control equipment. If you don't take good care of it, it will smash and will strike, so that you pay a high maintenance fee.

Therefore, the daily maintenance of the engraving machine becomes a primary school question, which is worth learning and discussing.

"See the tricks" engraving machine maintenance points:

(1) First, comprehensive inspection of the engraving machine. Remember to turn off the power, wait until the display is not displayed and the main circuit power indicator is off.

After that, you can carry out all-round inspection. Look at the drive shaft, the driver and other components are loose, broken or fall off, the working circuit, the line is

Is it normal?

(2) to ensure that the working environment is dry, the air dust is less, and there is no corrosive substance; every time the machine is used, it is necessary to pay attention to the cleaning and the platform and

The dust on the drive system is cleaned up.
(3) Lubricate and refuel the corresponding shafts of the transmission system according to the cycle. Here is a detail worth noting: X, Y, Z three-axis polished rods are maintained with engine oil

Screw rod department plus high-speed butter; winter if the working environment temperature is too low, screw rod, polished rod, square rail or circular guide should first use gasoline

Rinse and clean, then add the oil, otherwise the resistance of the machine transmission department will be too large and the machine will be misaligned.
(4) Continuous operation for more than 10 hours to ensure the cleaning of the cooling water and the normal operation of the water pump, remembering that the water spindle motor cannot be made up

The water phenomenon ensures that the cooling water is replaced regularly to prevent the water temperature from being too high and the equipment to be lost. If the working temperature in the northern winter is too low, the water can be put

The water in the box is replaced with antifreeze to prevent freezing and cannot be cooled, causing equipment to collapse.
   In addition to the above four main points, there are many small details on the maintenance of the engraving machine. I will not repeat them here. The details can be communicated to our technical staff.

Give you a satisfactory solution!